Wood Underlayment

This 10 mm thick black rubber pad is our under-bamboo soundproofing. It's also from Sound Isolation Company. Wood floor soundproofing requires different materials and since our subfloors are ply wood and not concrete, we need a thicker pad than someone might use in a new high-rise condo. The pad is made from 93% post-consumer waste like as tires and old dodge balls. It's extremely heavy. One 4' x 25' roll weighs over 200 pounds, and we'll use close to 5 rolls. That's half a ton of soundproofing on our kitchen and living room floors.

Thanks to Matty Cat for lending us his heft this evening. Matt and Justin lugged these things up unfinished deck stairs and it was precarious, if not somewhat dangerous moving the behemoth rolls of rubber. We'd also like to thank Matt for his help a few weeks ago hanging insulation in the basement bedroom ceiling. (That too, was a soundproofing project.) Matt and Karen have been a huge support to us through this project and we'd be filling our milk with tears without them.

Fresh Tile No Traffic Until Tues Thanks

Today, Rude (pronounced "Rudy" for those calling him "rude," which he rarely is) planned and set the bathroom floor tile in place. We're using 3/8" thick Brazilian Black Slate which appears to be considerably strong given that it's stone, not ceramic. Rude tells us that stone tile normally ships in thicker grades.

The fuchsia wall coating is a waterproofing membrane that goes on a bit like liquid plastic. Once it's dry, it'll form a watertight barrier behind the tile. Water that does get behind the tile will run down to the floor tile and, with luck, either evaporate away or evacuate the room through the floor drain.

Tile Underlayment

Yesterday and today we've spent some time installing a layer of sound isolation barrier, which goes on top of the subfloor and beneath the finished floor. Since we have living space in the basement, we're hoping to keep noise isolated in each space. In the ceilings on the first floor we used spray foam insulation to keep noise from going through the ceiling into the upstairs bedroom. Given the foot traffic we'll have on the first floor, we are adding the additional layers of underfloor material.

For tile we're using a 3 mm thick styrofoam-like composite material with an adhesive backing, made by Sound Isolation Company. Our good friend Rude (of Portland Cement Co. and who's laying our tile and pouring our countertops) tells us that this stuff is great to work on and that it takes thin set (the mortar mix used to hold tile in place) as well as Wonderboard does.

Frosty Glow

This is a fluorescent wall sconce in the stairwell on the landing between the first floor and basement.

Kitchen Paint

The kitchen alcove and bump out are brown and we extended the white of the ceiling onto selected sections of wall here and in the living room. The white in between the sections of color adds a lot more interest to the room and brings out the varied geometry of the walls.

Living Room Paint

The living room has gone from all walls orange to one wall orange. Last night Chano and Leo finished the first coat of orange on the whole living room and when Rachael and I saw it, we simply didn't like the way it abutted the brown walls in the kitchen. So we scaled it back a little and went with a white living room and a single orange accent wall, which we like a lot more.

Power Up

The first new light fixture.

Remodel Exhaustion

A tired owner takes a thirty second breather. We're nine days from move-in and getting tantalizingly close to the end of the project. The siding is nearly all on. Only the living room remains for painting. Trim out electrical and tiling both start tomorrow.

Urban Panda

Very rare. Spotted on our garage roof this evening, angling to get at the bowl of cat food sitting in the back yard.

Porch Progress

The rafters and sheathing are on the front porch.

Porchsign

At last, the ghost of a front porch appears. The structural timbers are 4x4 Ipe, which is the same material we're using for the handrail posts on the rest of the deck.

Rear Deck Prep

The concrete footings for the back deck, poured yesterday, are hard to see in this photo. The pressure treated ledger went on today. The inside corners created by the stair tower have slowed things down from time to time, mostly because of runoff water management. We don't want water getting in the cracks and causing damage inside the structure or behind the siding, so getting the flashing cut right and in place correctly is somewhat tedious work.

Construction on the rear deck should begin on Friday or early next week.

The 90 Degree Shot

It reached (or got very close to) 90 degrees F today. Rachael brought in lemonade for the crew at 10:30 this morning to help cool things down. Despite the heat, more of the Tyvek wrap disappeared under the steadily growing field of cedar siding.

• 5/31 :: Daniel adds : That cedar siding is so good looking, are you going to paint it?

• 5/31 :: We add : It's paint-grade cedar, so because of the glue that helps keep it together, we're obligated to put some kind of protective coating on it. We were initially thinking we'd stain and seal it, but we think the UV will still pass through whatever clear sealer we use and compromise the glue. We've also been cutting and mounting it with gaps along trim to allow room for caulk, which we wouldn't do if we were hanging stain-grade cedar. This bare cedar does look good, but we're pretty confident we'll have an equally good look once the paint is on.
  

Kitchen Paint

The Jackson Tan is creeping into the kitchen from the hallway (at left behind ladders). Those are paint spots on the walls, not a dirty lens. Rachael and I did some finger painting this evening to color code the walls for the painters.

Red Room Reborn

Now that the carpet is in (thanks Dave!), the second floor bedroom is starting to look a lot like our bedroom at the Liebe Street house.